Your ball joints are a necessary component of the front suspension of practically every automobile. This component provides easy movement between the control forces of your vehicle and the steering knuckles so that you can drive smoothly and safely, allowing you to control the wheels of your car effectively.
There are several ways to remove ball joints. But most of the way to apply, you will need a ball joint press or separator tool, but they are a bit more expensive. However, there is no reason to worry because you can also remove ball joints without using any tools.
With that in mind, we will now try to highlight some of the Ball joint removal tricks here, for which you will not need to use any tool. If you want to know more about ball joints and why this is important then just visit autoevaly.com. So, let’s get started.
Step 1:
Wear safety clothes before starting work. This is a very important step. You can never begin an automotive-related task without wearing safety clothes. So, of course, you have to wear safe clothes.
Step 2:
Now you need to lift your car. Ensure the vehicle is stationary on an even surface and remove any objects on top of your car. Axle nuts and log nuts hold your wheel; Some car models have axle nuts attached, so you may need a screwdriver to open the cover. Do it carefully. Loose nuts can prove difficult to remove, especially when they are all rusty. Rotate the log nuts one quarter each; Do not remove them completely.
If you are using a jack, you need to set your jack properly on a hard point in your car. Using soft parts can damage parts of your vehicle. If you’re not sure where to put the jack, let us know. We will show you the best and safest position to set up your jack, and the jack is standing based on your car model. After lifting your car with your jacks, place your jack in tight positions under your vehicle.
Make sure your jack stands are well placed so that the jack stands will distribute the weight of your car evenly. Now turn off your wheel log nuts completely so that you will be able to remove the wheels from your vehicle. It is not advisable to use a car lift for this process because of the method we have to use to get it done. However, when using a ball joint divider, you can consider lifting your car with a car lift.
Latest update: updateperdana
Step 3:
Your vehicle is lifted and held all over by your jack stands. Now place your jack directly under your axle hub where the ball joint goes down. You can put pieces of wood between your axle hub and jack. Then gently raise the hub a bit. Now you should use a hammer to separate the bottom of your joint from the top.
Always be aware of where you are hitting. It will take some time and different angles to break your ball. But when it finally breaks, you will hear and hear the sound. Be careful when using your hammer to hit the housing.
Step 4:
Now that you have everything separate, this is a great time to double-check your other joints. Check if you have a bad CV joint or other defective material. If errors are found, you can use this opportunity to replace them. Clean any debris or dust.
Step 5:
Use your hammer to take off your bad ball joint completely. This may require some more tools. If not, your ball will not hit the joint. Get ready to install your new joint. The joint should sit in a well-cleaned place before installing joint. You can also apply lubricant to the interior.
What does the ball joint do?
Ball joints connect the control arm and the fork or spindle that turns your wheels and can go up and down when you are driving. Usually, these parts bear a huge punishment. Some hold the weight of the car, and small causes or design errors can cause a ball joint to fall off prematurely and even fail, potentially costly car damage. So if you have symptoms in your car, it is important to take the time to check the ball joints for wear to avoid major problems later on.
Final Thought
Not many people know how to remove ball joints. Although ball joint removal is not a very difficult task, you can never do it if you do not know the correct method. We have tried to highlight in our article about ball joints removal tricks. Hopefully, this small effort of ours will help you enough to do this work. Thank you all.
Read Also: Click